Murray, often seen around sksboards, offers a different variant (no thumbscrew on the valve, instead mode is switched by a wrench). You should also crosspost your issue on if you have not done so already.ĬNCWarrior offers a same-type newly-milled replacement valve. It is always nice to have another working SKS sitting beside the one you're troubleshooting for this issue, because you can sometimes interchange the parts until you find the culprit. Also, the gas tube itself can be at fault which would be my next guess if you replace the gas valve without success. When the rounds don't eject and instead stay in the chamber (and sometimes cause a sticky bolt), the gas valve is often thought to be a culprit when it might be pitted and worn. Can anyone think of anything else I should check? The gas piston now floats freely, and I can see that the gas port is clear (at least it is now). I'm thinking (hoping) this was caked up cosmoline melting and burning off. It stank up the room and pushed out a lot of black smoke. I noticed that a lot of stuff was burning off. I then took out a lighter and stuck the flame inside the gas block. I cleaned it and the gas tube, as well as the secondary piston inside the rear sight base. It would move, but only with some force-then it would fall free. I took it home and cleaned the gas system, the piston seemed sticky in the tube. If it were the ejector it would cycle but have issues ejecting. The spent case doesn't even cycle the bolt. My first thought was the obvious, make sure the gas port isn't switched closed. Out of 50 rounds only three cycled at all, and those stovepiped. It doesn't have a problem feeding some ammo-it has a problem feeding ALL ammo. I wasn't too worried about it, figuring it just needed a good chamber cleaning like so many SKS's do. Before he sold it to me he stated that it had issues feeding some ammo. I picked up a Yugo SKS last week from another forum member. If you run into an IP ban, it likely wasn't you. We try not to ban legit subscription VPN services, but they rarely label their IP blocks correctly. We do not ban legit Internet Service Providers from the USA(exception for certain individual IP addresses). If you run into a IP ban afterwards as a member, again - turn off your VPN or switch servers. Failure to do so will result with your new account denied. When signing up, do so from a US based Internet Service Provider.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |